IAS Aroid Quasi Forum

About Aroid-L
 This is a continuously updated archive of the Aroid-L mailing list in a forum format - not an actual Forum. If you want to post, you will still need to register for the Aroid-L mailing list and send your postings by e-mail for moderation in the normal way.

  RE: [Aroid-l] Anthurium
From: "D. Christopher Rogers" crogers at ecoanalysts.com> on 2006.11.14 at 17:34:05(14810)







Dear Tom,



Thank you for the advice. Anthurium is a new interest of mine, as I
typically have been focused on the tuber bearing aroids (Amorphophallus,
Dracontium, Anchomanes, Cryptocorne, Arum, Typhonium, etc.) But, I am pleased
that my Anthurium harrisi has just pushed out its first flower.



I am trying to keep the light levels the same as what the parent plant
has. The parent is in a whitewashed greenhouse under a canopy of tree ferns,
orchids and Monstera. The leaves on the parent are nearly black with silvery
white veins. The two ‘babies’ came from the base of the main stem, where there
was very little light penetration, and these leaves are very pale green. So, I
am a little concerned about them being burned. I have them under my son’s
orchid bench, in a high humidity (80%) environment, with the orchids that need
low light conditions. So, as our winter sets in, temperatures in my greenhouse run
from 12 degrees C at night to 26 degrees C during the day. I am installing a
propane heater that will keep the temperatures a bit higher. Any further
comments or suggestions?



Thanks,

Christopher



AUTOTEXTLIST \s "E-mail Signature"
D. Christopher Rogers
+More
Note: this is a very old post, so no reply function is available.